Photovoltaic Conversion Efficiency Terms +
(solar electricity technical terms applying to electricity, power generation, concentrating solar power, or CSP, solar heating, solar lighting, and solar electricity)
lead-acid battery, lead acid battery
A general category that includes batteries with plates made of pure lead, lead-antimony, or lead-calcium immersed in an acid electrolyte.
life
The period during which a system is capable of operating above a specified performance level.
life-cycle cost, life cycle cost
The estimated cost of owning and operating a photovoltaic system for the period of its useful life.
light trapping
The trapping of light inside a semiconductor material by refracting and reflecting the light at critical angles; trapped light will travel further in the material, greatly increasing the probability of absorption and hence of producing charge carriers.
light-induced defects, light induced defects
Defects, such as dangling bonds, induced in an amorphous silicon semiconductor upon initial exposure to light.
line-commutated inverter, line commutated inverter
An inverter that is tied to a power grid or line. The commutation of power (conversion from direct current to alternating current) is controlled by the power line; so, if there is a failure in the power grid, the photovoltaic system cannot feed power into the line.
liquid electrolyte battery
A battery containing a liquid solution of acid and water.
Distilled water may be added to these batteries to replenish the electrolyte as necessary. Also called a flooded battery because the plates are covered with the electrolyte.
The demand on an energy producing system; the energy consumption or requirement of a piece or group of equipment. A load is usually expressed in terms of amperes, or watts in reference to electricity.
The wire, switches, fuses, etc. that connect the load to the power source: In order to activate an appliance in Jane's home, the load circuit was necessary for them to function properly!
The current required by the electrical device: The load current is the flow of electricity through a conductor from a power source to a device and is absolutely important for it to function properly and safely.
The resistance presented by the load: Load resistance is the impedance which a load furnishess to the flow of electric current in a circuit
low voltage cutoff; LVC
The voltage level at which a charge controller will disconnect the load from the battery.
low voltage disconnect
The voltage at which a charge controller will disconnect the load from the batteries to prevent over-discharging.
low voltage disconnect hysteresis
The voltage difference between the low voltage disconnect set point and the voltage at which the load will be reconnected.
low voltage warning
A warning buzzer or light that indicates the low battery voltage set point has been reached.
Index of additional Scientific and Technological Topics.

